BMW Auto klub ČR

Gerchan píše:

JaraX píše:děláme to s tannerem, ale zatím jen pro naše zákazníky.
nebo si ho můžeš objednat z ebaye od Logic 7

Úplně nejraději bych si koupil termostat, dal ho do hrnce s vroucí vodou a zkusil jestli opravdu otevírá dříve než originál - než ho tam namontuju.
Takže mě asi nic jiného než si to objednat z ebay nemine...když je ten váš pro volný prodej nedostupný...

Tady jsem to našel na německém ebay:
https://www.ebay.de/itm/BMW-OEM-90C-194 ... SwNnRYfZLs

TANN3R píše:Ten ruskej postup, co tu dával zddan01, sice funguje, ale jen tak napůl. On tam je jeden problém, kterej tam zapomněli napsat.

JaraX píše:sere se to, ale sere se celá šestka, tak to tam hezky zapadne. vzhledem k tomu že zvuk zavření dveří šestky připomíná konzervu, tak to je super upgrade.

Locking Procedure
(When door is pushed into the lock starting position)
Door open, the automatic soft close function is in the standby position.
When the door is closed normally, first the locking pawl (lock) Hall sensor changes its status.
The electronics in the automatic soft close function drive start the door closing operation
after a delay of 200 ms. This prevents the automatic soft close function drive starting
before the lock bolt is located in the rotary striker.
The drive operates the rotary striker by way of the Bowden cable until the Hall sensor for
the rotary striker changes its status. The locking pawl is then engaged and secured in the
rotary striker. Control over the automatic soft close function drive is then withdrawn and
the automatic soft close function drive moves to the parked position.
When the door is opened using the outside door handle (bow handle) or inside door
handle, the system runs back to its original position. This is also known as the standby
position.
Note: Only when the rotary striker sensor has changed its status is the rotary
striker mechanically locked by the locking pawl. This is particularly
important, as only then is it guaranteed that the door is truly closed.